SunStar Heating Products Infrared Ceramic Heater – NG, 30,000 BTU, Model# SG3-N

Constructed from aluminized steel for corrosion resistance and long life
Aluminum reflectors are designed to maximize radiant efficiency
Heaters can be angle mounted horizontally and up to 30 degrees

Category:

The SunStar Heating Products Ceramic Heater is ideal for spot heating or area heating of remote locations, farm buildings, shops, service areas, pump houses or other hard-to-heat spaces, providing both fuel efficiency of radiant heat and installation flexibility not really helpful for car washes. That is an energy-saving Direct Spark Ignition heater and will also be controlled by a line Volt or 24V thermostat sold one by one. May require the following second stage regulators prior to the heater in keeping with gas supply pressure A regulator as much as 2 PSIG line pressure or a regulator above 2 PSIG line pressure both sold one by one. NOT CERTIFIED OR APPROVED FOR RESIDENTIAL USE. Indoor use only. U.S.A. Please review the detailed Installation & Operating Instructions attached for other specific installation req gas pressure, ventilation and so on. prior to purchasing the heater. Vent-Free No, Gas Inlet in 1/2, Heat Settings Thermostatically controlled, Dimensions W x D x H in 23 x 31 x 11, Thermostat Not Included, Igniter Direct spark, Remote Not Included, BTU Output 30,000, Heating Capability sq. ft 500-1,500, Blower Not Included, Fuel Consumption gal./hr. 0.3, Product Type Radiant heat, Fuel Type Natural gas. Comprised of aluminized steel for corrosion resistance and long life Aluminum reflectors are designed to maximize radiant efficiency Heaters will also be angle mounted horizontally and as much as 30 degrees The min mounting height is 12ft above finished floor for uniform energy distribution and human comfort Requires the following clearances from any combustible material 37in above, 73in below and 31in from the sides of the heater The min supply gas pressure is 7.0in Water Column WC and the Max supply pressure is 14in WC gas pressure If higher gas pressure is supplied, it is important to install a line pressure regulator sold one by one to reduce it to lower than 14in WC or 1/2 PSIG No assembly required Heaters are 100 test-fired prior to shipment CSA design certified
Comprised of aluminized steel for corrosion resistance and long life
Aluminum reflectors are designed to maximize radiant efficiency
Heaters will also be angle mounted horizontally and as much as 30 degrees
The minimum mounting height is 12ft. above finished floor for uniform energy distribution and human comfort
Requires the following clearances from any combustible material: 37in above, 73in below & 31in from the sides of the heater

Reviews

There are no reviews yet.

Be the first to review “SunStar Heating Products Infrared Ceramic Heater – NG, 30,000 BTU, Model# SG3-N”

Your email address will not be published. Required fields are marked *